Masima 2405 Rainbow RC-1 Patient Cable
Masima 2405 Rainbow RC-1 20-pin Patient Cable 1FT, Use with Rainbow and M-LNCS Sensors
► Brief Description
Masima RC-1 2405 Rainbow 20-pin Patient Cable is used to connect Rainbow and M-LNCS Sensors. It is a professional medical device for SpO2 detection for patients. It is a specially designed product, so please be sure to carefully check the compatibility between the tester, lead wires and sensors before use, otherwise some accidents may occur, including performance degradation or even patient injury. Before using this Masima RC-1 2405 Rainbow 20-pin Patient Cable, there is one more necessary step to make sure that the cable is in good condition with no broken or frayed wires or damaged parts. Visually inspect the cable and discard if cracked or discolored.
► Specification
| Brand | Masima |
| REF | 2405 |
| Product Category | SpO2 |
| Product Type | Patient Cable |
| Product Set | Rainbow RC-1 |
| Number of pins | 20-pin |
| Cable Length | 1 FT |
| Condition | New and Original |
► Caution
1. When using the Masima RC-1 2405 Rainbow 20-pin Patient Cable to examine patients, please pay attention to carefully arrange the cable and sensors to avoid winding or affecting the patient;
2. To avoid damage to this Masima RC-1 2405 Rainbow 20-pin Patient Cable, always hold the connector and not the cable when connecting or disconnecting either end;
3. After using the Masima RC-1 2405 Rainbow 20-pin Patient Cable, to prevent damage, do not soak or immerse the sensor or cable in any liquid solution. Do not try to sterilize the cables or sensors, they should be handled under the guidance of the instructions;
4. After discovering that this Masima RC-1 2405 Rainbow 20-pin Patient Cable is damaged, do not attempt to reprocess, repair, or recycle the Masima sensor or patient cable, as these processes may damage the electronics, which could result in patient harm.
► Environmental Parameters
| Temperature | Operating | 41°F to 104°F (5°C to 40°C) |
| Storage | -40°F to 158°F (-40°C to 70°C) |
| Relative humidity | non-condensing | 10% to 95% |
► Regarding Cleaning
First remove the sensor from the patient, then disconnect the sensor from the lead wire.
Then wipe all surfaces of the lead wire with a 70% isopropyl alcohol swab;
Take another cloth or gauze swab dipped in sterile or distilled water and wipe all surfaces of the lead wire again;
Finally wipe with a clean cloth or dry gauze swab Wipe all surfaces of the lead wire dry.
► Detailed photos
Thank you for your time. If you are interested in our company or our Masima SET 2405 Rainbow RC-1 20-pin Patient Cable 1FT, For Use with Rainbow and M-LNCS Sensors, or have any suggestions for us, please feel free to contact us. We will reply you within 12 hours. Wish you a happy life.
Product Tags:
|
|
Masima Set 2405 Rainbow RC-1 20Pin Patient Cable 1FT With M-LNCS Sensors Images
|
